Here’s What You Need:
*Piece of Wood from a Pallet
*Wording you like printed out to size
*Punch Awl
*Painters Tape
*Drill or Drill Press and a 1/8″ drill bit
*Yarn
*Large Yarn Needle
*Sawtooth hanger hardware and ruler
*Circular saw or handsaw
Instructions:
The first thing you need to do is print out your wording. Find a font you like and resize it until the height and width of the font are to fit your board. My pallet piece was a little over three and a half inches tall so I made sure my font was a little smaller than three inches. Once you have your print out, tape the paper down to the pallet wood board making sure your wording is centered.
Take your punch awl and punch holes into the wood through the paper every half an inch(a little less on curves), all around your wording. Punch every letter until you have the whole thing punched.
Next, carefully drill through your wood where each punch is marking the letters. Be careful. If you are having a hard time seeing the punch marks, you can mark them with a marker to help you see them better. Drill through every punch mark on every letter until you get to the end. Once all the holes are drilled, clean off the wood so there isn’t any dust that will dirty your yarn.
Cut a long piece of yarn and thread one end through the needle. Double knot the end of the yarn. Now bring the needle up through the bottom of the wood through the first hole in the first letter.
Happy Crafting!