diy: Rhinestone and Bow ID Case

When I was younger, I used to adore Hello Kitty. Today, I might be (almost) in my mid-20s, but I still love her just as much. Its one of those things that keeps life fun and cute...especially when you have to start growing up. We all know gets life super stressful sometimes, so I think its always nice to have something not-so-serious around. (This is coming from a girl who takes notes for graduate classes in bright green gel pens. Might as well make it fun!).I recently made an ID case, inspired by Hello Kitty. I kind of like that it isnt exactly Hello Kitty, but her bow is iconic enough to stand on its own. It was inspired by this card holder by Swarosvki:Photo Credit: Swarovski.com, $195Of course, my version wasnt made out of Swarovski crystals. I spent less than $10 to make this...much less than the original! Check out how I made it below:Supplies:- Large plastic flatbacked bow* - Plain ID case(...or an ID case with a decal that can be removed, like mine.)- Rhinestone trim - Super glue/E6000- Scissors and jewelry pliers- Rhinestone flat gem (optional)*I bought mine from Etsy. Its about 2 inches wide. You can also use an actual ribbon bow, or an applique. The rhinestone trim I used was from Michaels. It was fairly inexpensive - a couple of dollars - and even has adhesive on the back. Its essentially like one long sticker. Of course, its up to you if youd like to spend a little extra and buy really nice, more expensive rhinestone trim. Theres a lot of options at fabric and trimming stores, like MJtrim.com!1) I bought this ID case on sale at The Icing a few months ago. It was in the bargain bin, so it was probably around $2-3. I had this project on my mind for a while, so when I saw that the decal could be peeled off, I knew it would be perfect. Using the pliers, I lifted up a corner of the decal and carefully peeled it off. If your ID case is just a flat surface, then you can just skip to the next step.2) I cut the rhinestone trim to fit into the width of the ID case. Because the trim is fairly wide (1.25 inches), two strips was just enough. Each strip was about 3.25 inches long. Obviously, this might differ depending on the width of your trim. 3) I peeled off the adhesive backing, and glued the trim to the case. Pressing down will help for extra security. 4) Next, I glued on the bow, then let it dry overnight. My roll of rhinestone trim had just enough for two ID cases...which is awesome, considering I had been planning on making 2 anyway. One for myself, and one for my friend Kat! We happen to feed into each others Hello Kitty obsessions :)xo!