SPLIT BACK TINY POCKET TANK : THE TUTORIAL
Anyone remember the Split Back Tiny Pocket Tank that I wrote about way back in July? I had at least one comment requesting a tutorial, so here we go!
The first thing that you will need is Grainline's Tiny Pocket Tank pattern, which is available for purchase online in a print at home format. This is seriously one of my all time favorite patterns. I have used it and altered it more times than I can count and I've never been disappointed with the results.
STEP ONE : ALTER THE PATTERN
The best part of this tank variation is that you really only need to alter one pattern piece: the back. Begin by tracing the tank back face up on pattern paper. Next, flip the tank back face down and line up the center back of the pattern piece with the center back that you just traced. With the tank back face down, trace again along the neckline and up across the shoulder seam.
Using your straightedge, draw a line that is perpendicular to the red line and goes through the part of the pattern where the armhole and side seam meet. This line is shown above in gray. Note where the red line and gray line meet. This point of intersection will be used as a starting point for a curve.
Draw a curve from the intersection point mentioned above, to the bottom of the side seam.
STEP TWO : CUT YOUR FABRIC
Cut 1x center front on fold Cut 2x altered back pattern piece. Place the original center back on the straight grain of the fabric. Also, make a mark along the neckline of each back piece to represent the placement of the original center back line. These marks will be lined up when we overlap the split back pieces. Cut 1x neckline binding on bias grain. Cut 2x armhole binding on bias grain.
STEP THREE : SEW
For most of the sewing, you can follow the sewing tutorial from Grainline, but I will summarize my steps below.
Sew front darts and press.
Use French seams to sew the sides and shoulders.
Follow Grainline's tutorial to insert armhole bias binding on both sides.
At this point you will finish the hem of the tank. Don't forget that the "hem" of this variation runs all the way up along the curve that we made in the altered back pattern piece. I finished this hem using bias binding and Grainline's tutorial, but you can use your preferred hemming technique.
At this point all the edges will be finished, except the neckline, and the back will be open. Locate the marks that you made while cutting the back pattern pieces. Line up the marks and baste along the neckline where the two back pattern pieces overlap. Finally, follow Grainline's tutorial to insert the neckline bias binding.
At this point you may also sew along the "hem" where the two back pattern pieces overlap. This will keep the split back from flying open.
STEP FOUR : ADMIRE YOUR WORK
Let me know if you end up making your own split back tiny pocket tank! Happy sewing!
More posts from
